*   NAME: Z5000411  PRODUCT: SASC     CATEGORY: SPEC    SYSTEM: CMS
*   DATE: 06AUG92   STATUS:  DZ+UT    USAGE-ID: LIBRARY-C0411
*
*   Defining exclamation point as right bracket fails during assembly
*
*   NOTE:      APPLY THIS ZAP TO THE sasc.MACLIBA LIBRARY USING THE
*              FOLLOWING STEPS.  THIS ZAP IS A SOURCE UPDATE AND
*              SPECIAL HANDLING WILL BE REQUIRED.
*
*         (2) Update the CHARSET member of the LCUSER MACLIB.
*            (a)  Edit the CHARSET MEMBER of LCUSER MACLIB.
*                    XEDIT CHARSET
*            (b)  Stop XEDIT from resetting the serial numbers.
*                    SET SERIAL OFF
*            (c)  Save the member to a file named CHARSET COPY A.
*                    FILE CHARSET COPY A
*            (d)  Apply the update to CHARSET COPY A.
*                1- Copy the below statements to a file named
*                   U5000411 UPDATE A
*                2- Edit U5000411 UPDATE A and change all occurrences of
*                   '*/' back to './'.  Also, ensure that all comments
*                   before the first './' are removed.
*                3- Save the file.  Update CHARSET COPY by doing the
*                   following:
*                    UPDATE CHARSET COPY A U5000411 UPDATE A (REP
*         (3) Put CHARSET COPY back into the LCUSER MACLIB.
*                    MACLIB REP LCUSER CHARSET
*                    MACLIB COMP LCUSER
*
*   NOTE: The following is a SOURCE UPDATE;  to apply, you must
*         (1) ensure that the target source file has not been re-numbered,
*         (2) change all occurrences of "*/" back to "./", and
*         (3) remove all comments before the first "./" card,
*         before using the CMS UPDATE command
*/ R 50000 60000
               82,81,7F,7E,7D,7A,61,60,6F,6E,6D,6C,6B,50,              *00050000
               5E,5D,5C,5B,40,4E,4D,4C,4B,15,05,0D,0C,0B),             *00060000
*/ *           --- UPDATE FILE ENDS HERE -----------------------------